Media Library / Images

Ship loading with chemicals

UTS 150 hose assembly, ARK-S Safety Break Coupling

Hose assembly TW 63 with VX 63-11/2" and DDC-M 65 Al

TW hose with Dry Disconnect Coupling

ELAFLEX Hamburg, stock bellows

AMK 25 EASY

EASYLOC ('Camlock' stainless steel coupler to EN 14420 - 7 for male adapters AVK with captive seal) with lever arrest

VR Hose Reel Spring Rewind red, ZVA Slimline 2 GR green, ZAF 2

for active Vapour Recovery (VR) for gasoline fuels

Road tanker with large reel, HD hose assembly, ZV 500 nozzle

HD 100 C Neon, HD 10 sensing hose

Aircraft Dispenser with DN 100 hose (spiralised marking) and a sensor hose to control the hydrant system.

SPANNLOC bolted safety clamps of stainless steel

SC 75 SS

Customer protected special design ZVA Slimline 2 nozzle

ERV-G Yellow Band rubber expansion joints, manhole of a petrol station

ERV-W 80.16 ZS 2

White Band Rubber Expansion Joint with "ZS" limiter (tie rods with outer limitation in rubber bushings)

SVC 50-2"

Male hose coupling of steel with Spannloc clamps

MK 80-90 SS; MK coupling stainless steel with bent lever 90°

TW coupling with bent lever: For any application it should be checked that the lever can be arrested as shown even if there is tight space. Elaflex offers bent levers for all MK couplers.

ELAPAC FD 174 flange seal

Hose Reel with manual rewind blue, TW 100, DDC-M 100 SS

Marine terminal, with grey cabinet, customised

UTS hose assembly, rail tanker top loading

SSB 16 LV

Safety Swivel Break, for ZVA AdBlue LV. Calibration switch 10 l/min - 5 l/min

DDC-M 100 SS, Elaflon Plus FEP, VC 100-4" SS

Terminal loading / unloading of chemicals with Dry Disconnect coupling and universal hose

Type PCS, Polypal Clean

one side with RMC foodstuff fitting / Spannloc clamps stainless steel, other side open (note the inner conductive stripe)

SG 1½" Al

Ssight glass for ZVA 32 nozzles, e.g. for aviation refuelling.

PSB Pump Safety Break for High Hose Dispensers

Picture shows separation of the Slimline hose assembly after a drive-off accident

Terminal / gantry: 'Polypal Oil' hose assemblies for bottom loading of road tankers

Lining UPE - resistant to all petrochemical media, also with high content of aromatics or other aggressive additives; cover CR - oil resistant

ZVA Slimline 2 LA nozzle with LeverAssist hold-open aid

ContiTech Production hose

Dispensing hose extrusion

Storz Safety Couplings Type SHK

upon uncoupling, the safety dust plug first falls into holding claws, relasing an eventual pressure within the system. Only then the dust cap can be fully taken off. - increased protection for the operating personnel. Easy to use, no additional pressure release necessary, slim design, does not build up, no freezing up in the dome section.

ERV-G Yellow Band rubber expansion joint, installation underneath a road tanker

ContiTech Production ERV

In production testing, rubberized fabric

ZVF 25 for aircraft refuelling

dust cap and ground cable assembly

Cabinet of road tanker:

MK 80 with VB 80 ADR SS (plug with pressure relief)

Rubber Expansion Joint ERV-OR 80.25

ORANGE BAND expansion joints for Liquid Petroleum Gas (LPG) to EN 589. For tank trucks and refuelling stations. Temperature range (depending on medium) - 20° C up to + 90° C, temporarily up to 100° C. Electrically dissipative.